Concept
NMOS logic
Overview
NMOS or nMOS logic (from N-type metal–oxide–semiconductor) uses n-type (-) MOSFETs (metal–oxide–semiconductor field-effect transistors) to implement logic gates and other digital circuits.
NMOS transistors operate by creating an inversion layer in a p-type transistor body. This inversion layer, called the n-channel, can conduct electrons between n-type source and drain terminals. The n-channel is created by applying voltage to the third terminal, called the gate. Like other MOSFETs, nMOS transistors have four modes of operation: cut-off (or subthreshold), triode, saturation (sometimes called active), and velocity saturation.
NMOS AND-by-default logic can produce unusual glitches or buggy behavior in NMOS components, such as the 6502 "illegal opcodes" which are absent in CMOS 6502s. In some cases such as Commodore's VIC-II chip, the bugs present in the chip's logic were extensively exploited by programmers for graphics effects.
For many years, NMOS circuits were much faster than comparable PMOS and CMOS circuits, which had to use much slower p-channel transistors. It was also easier to manufacture NMOS than CMOS, as the latter has to implement p-channel transistors in special n-wells on the p-substrate, not prone to damage from bus conflicts, and not as vulnerable to electrostatic discharge damage. The major drawback with NMOS (and most other logic families) is that a direct current must flow through a logic gate even when the output is in a steady state (low in the case of NMOS). This means static power dissipation, i.e. power drain even when the circuit is not switching, leading to high power consumption.
Another disadvantage of NMOS circuits is their thermal output. Due to the need to keep constant current running through the circuit to hold the transistors' states, NMOS circuits can generate a considerable amount of heat in operation which can reduce the device's reliability. This was especially problematic with the early large gate process nodes in the 1970s. CMOS circuits, for contrast, generate almost no heat unless the transistor count approaches 1 million.
CMOS components were relatively uncommon in the 1970s-early 1980s and would typically be indicated with a "C" in the part number. Throughout the 1980s, both NMOS and CMOS parts were widely used with CMOS becoming more widespread as the decade went along. NMOS was preferred for components that performed active processing such as CPUs or graphics processors due to its higher speed and cheaper manufacturing cost as these were expensive compared to a passive component such as a memory chip, and some chips such as the Motorola 68030 were hybrids with both NMOS and CMOS sections. CMOS has been near-universal in integrated circuits since the 1990s.
Additionally, just like in diode–transistor logic, transistor–transistor logic, emitter-coupled logic etc., the asymmetric input logic levels make NMOS and PMOS circuits more susceptible to noise than CMOS. These disadvantages are why CMOS logic has supplanted most of these types in most high-speed digital circuits such as microprocessors despite the fact that CMOS was originally very slow compared to logic gates built with bipolar transistors.
Overview adapted from Wikipedia (CC BY-SA 4.0; see the article history for authors).
Possible passages
Found by search and not yet checked by a person; they may only mention the idea in passing.
Please remember that the names are technical names, meant, no doubt, to be suggestive, but used in strictly defined senses. We have suffered much from critics who consider it sufficient to criticise our procedure on the slender basis of a knowledge of the dictionary meanings of such terms. For example, a one-to-one correlation depends on the notion of a class with only one member, and this notion is defined without…
Alfred North Whitehead, The organisation of thought, educational and scientific
States what NMOS logic is.
When this fluid has an opportunity of passing through two conductors, one good and sufficient, as of metal, the other not so good, it passes in the best, and will follow it in any direction. The distance at which a body charged with this fluid will discharge itself suddenly, striking through the air into another body that is not charged or not so highly charged, is different according to the quantity of the fluid…
Benjamin Franklin, Memoirs of Benjamin Franklin
States what NMOS logic is.
When two stimuli occur together, one of them, occurring afterwards, may call out the reaction for the other also. We call this an "ekphoric influence," and stimuli having this character are called "ekphoric stimuli." In such a case we call the engrams of the two stimuli "associated." All simultaneously generated engrams are associated; there is also association of successively aroused engrams, though this is…
Bertrand Russell, The Analysis of Mind
States what NMOS logic is.
Related ideas
- Integrated circuit
- Logical NOR
- MOSFET
- Transistor–transistor logic
- CMOS
- Electron
- PMOS logic
- Field-effect transistor
- Diode–transistor logic
Place in the tradition
Part of Logic gate.